AT-Command Module Tutorial ~ About First Time Connect To The DK

Raytac would like to remind following external MCU setting for first time connection with AT command DK Board.

1. Baud Rate: Default setting is 9600 without Flow Control
2. UART PD default setting is “Low”
   *a. MCU output set as “Low” to connect the DK Board
   *b. If MCU can not set up output “Low”, please use jumper to connect UART PD                 onto DK board to stay in “Low” (please refer to below pictures)
3. AT Command edit can only be committed under the DK boards is “No-Bonded” (Not Paired).
4. DK default broadcasting set as 30 sec and then enter to sleep mode. Developers can press wake up button to restart the broadcasting!
Tutorial 2-MDBT42A AT DK 拷貝Tutorial 2-nRF52810_AT-UART(52832-M9) Schematic.jpg

Provide the AT Command initial default setting as in below

(Pls refer to Spec Sheet Page 8 for more detail

Raytac Corporation
A BT4.1 & BT4.2 & BT5 module maker based on Nordic nRF51 & nRF52 solution 
(nRF51822 & nRF51422 & nRF52832 & nR52810 & nRF52840)
www.raytac.com            Tel: +886.2.3234.0208
email: service@raytac.com

Nordic nRF52810 AT-Command BLE Module By Raytac MDBT42Q-PAT

Raytac plans to release the AT command module, MDBT42Q-PAT, in April 2018, which is powered by Nordic nRF52810 solution.
Nordic nRF52810 AT Command Module-MDBT42Q-PAT.jpg